Dockstar serial cable putty5/10/2023 ![]() After a second or two you should see a bunch of text from the Dockstarâs U-Boot booting the image from NAND flash. 9 thoughts on Adding A Serial Port To A Dockstar cde says: Jat 5. Primary Ports: 1 x RJ45 Serial Port 5 x 10/100/1000 Ethernet Router Ports 1 x 1 Gbps SFP Ethernet Router Port 1 x USB 3. Connect up the SuperDroid cable, set HyperTerminal (or better yet, teraterm) to 115200 and the serial port youâre connected to, and turn on the Dockstar. A serial-to-USB cable is modified with a polarized pin header to ensure a quick and accurate connection. The Options controlling local serial lines page opens: Step 5. In the Category navigation field, choose Serial. Under the Connection Type field, click the Serial radio button. The PuTTY Configuration window opens: Step 3. Once those connections are made, find a way to attach it to the case of the Dockstar so that you can use the header while the Dockstar is snapped back together. In this case you would need to use COM4 for the Serial line to make the connection. ![]() Pin 1 is GND, pin 2 is +3.3V, pin 3 is RX, and pin 4 is TX on the SuperDroid header.Äockstar J1 should be connected to the SuperDroid header as shown: The following is the pinout of J1:įor the SuperDroid header, any 0.1â³ spacing header with four pins will do the trick. Only 4 wires are needed, and a small ribbon cable is helpful here, especially if the serial header is mounted so that you can access it without having to open up the Dockstar. The putty settings were (as described in the manual): Serial-Settings: Serial: COMX (in my setup COM5) Speed: 9600 Data bits: 8 Stop bits: 1 Parity: None Flow control: None Terminial/Keyboard Settings: Funktion keys and keypad: VT100+. Either remove J1 or solder wires directly to the pins. The trick was to attach the serial adapter before booting up the switch. The connector that has the TTL level serial port on it is J1. Connect to the EdgeRouter and log in using your credentials. ATTENTION: Replace /dev/tty.usbserial-AI038TPF with the value given when using the ls -ltr /dev/usb command. To access the console of an APC UPS, you will need to select the Serial connection category and use the following options: Connection type: Serial. Use the screen command to connect to console by pasting in the path to the serial interface. After finishing the download, run the software and wait for the following screen. Eventually all the tabs will be free and youâre now inside the Dockstar. Download a copy of the PUTTY software from the website. 18:27:45 ACTION starts following patch cables. Pry the bottom out slightly and then work your way around the perimeter of the bottom seam. 09:39:34 ah no, people want to have consolettyS0, but you cant.The case pops off relatively easy by inserting a screwdriver in the bottom seam that is below the LED that flashes in the front. This post will describe how to add a SuperDroid serial cable compatible header to the Dockstar.
0 Comments
Leave a Reply. |